Diamond Tour Golf

• PCF Series wedges offer a classic traditional profile with classic back flange design
• The PCF Wide Sole adds an extra wide sole to the platinum nickel styling of the PCF for added forgiveness
• PCF wedges are available in 52° gap wedge (RH), 56° Sand Wedge (LH or RH) and 60° Lob Wedge (LH or RH). Striking platinum nickel finish is available on all right hand PCF wedge designs
• P-Series wedges are investment cast for accuracy, but from a very soft stainless steel alloy (304SS) for a softer feel
• After casting, 304 Stainless has a natural hardness of Rockwell B83, which is actually lower than virtually all carbon steels used in forged irons
• The sole design puts the primary bounce sole angle on each P-Series wedge from the toe across past the center of the sole - then the bounce sole angle is reduced under the heel so the golfer can roll the face open, rest the wedge on the heel for a finesse or higher shot, and not have the primary sole angle cause the sole to "bounce" and blade the shot at the slow head speeds of real finesse shots.

Specifications

Iron	AW	SW	LW
Loft(+-1)	52	56	60
Lie(+-1)	64	64	64
Weight(+-3)	284	298	294
Toe Height	59	62	62
Heel Height	38	40	40
Bounce	5	11	6
Offset(mm)	2.0	2.0	2.0

Head Material	304 Stainless Steel
Scorelines	U-Groove
Diameter	.370 Parallel Tip
Hosel Depth	30mm
Finish	Nickel

TWGT warranties all products against damage or loss of integrity through normal course of play. This warranty applies to the life of the product. Player abuse is not covered under the warranty, nor is damage that occurs when contact is made at a place other than the face (i.e. the crown, skirt or sole of the clubhead).