The Rifle Project X Series took two full years of research and development. Project X features a longer taper rate than conventional steel shaft designs which enables the Project X to deliver a dynamic transfer of shaft energy to the golf ball. The "Flighted" iron shafts provide an exaggerated change in kick point within the club set to manipulate ball flight. Lower bend points in the long irons make it easier to get the ball airborne, while higher bend points in the short irons allow for lower trajectories and better ball control. This set is frequency coeffecient matched by electronic calibration with the Riflešs proprietary internal and external design.
Specifications
| Available Flexes |
Bend Point |
Launch Angle |
Shaft Length |
Weight (gr) |
Tip Diameter |
Butt Diameter |
Parallel Tip Section |
| 5.0 |
Progressive |
Progressive |
Variable |
115-135 |
.370 Parallel |
.600 |
Variable |
| 6.0 |
Progressive |
Progressive |
Variable |
115-135 |
.370 Parallel |
.600 |
Variable |
Flex Chart
| Flex |
5 Iron Swing Speed (MPH) |
Carry Distance (Yards) |
| 5.0 |
75-85 |
165-185 |
| 6.0 |
85-95 |
185-205 |
5.0=Regular Flex
6.0=Stiff Flex
Diamond Tour Golf Warranty Information
All Diamond Tour Golf merchandise is covered by a 1 year warranty against breakage under normal playing conditions. Any driver that dents due to a ball being struck outside the face will not be covered by warranty. Dents on the sole or on top of the club are not covered. Normal wear from play is not covered.
- If possible avoid hitting graphite shafted clubs off of driving range mats
- SMT drivers are covered by a lifetime warranty with no questions asked
Quantity Discounts are available for most of the components that Diamond Tour Golf carries. For the most accurate and lowest price, please call one of our staff members at 866-GOLF123 to receive a quote.
Butt Trim to desired length.