Diamond Tour Golf

The DT Ultralite is the lightest weight curvature matched (CM) steel shaft in our DT Series. With a weight near 100 grams and center of gravity slightly closer to the butt, the DT Ultralite helps to reduce club inertia and thus improve club acceleration during the downswing. This shaft is great for the golfer that prefers the light weight of graphite, but wants to improve consistency. This curvature-matched series may be considered the greatest combination of low inertia and launch reliability available on the market today.

Due to the ultra thin wall structure of this superlight steel product please use a 150 grit belt and light pressure when abrading tip for assembly. The same care should be taken as with a graphite shaft.

Specifications

Available Flexes	Bend Point	Launch Angle	Shaft Length	Weight (gr)	Tip Diameter	Butt Diameter	Parallel Tip Section
Regular/Stiff	Low	High	41"	100	.370 Parallel	.600	9"

Flex Chart

Flex	5 Iron Swing Speed (MPH)	Carry Distance (Yards)
Regular	70-80	155-175
Stiff	80-90	175-195

All shafts sold by Diamond Tour Golf are covered by a lifetime warranty against breakage under normal playing conditions. Normal wear from play is not covered by any warranty.

Quantity Discounts are available for most of the components that Diamond Tour Golf carries. For the most accurate and lowest price, please call one of our staff members at 866-GOLF123 to receive a quote.

Trimming Chart

Club	Regular
1 Iron	0"
2 Iron	1/2"
3 Iron	1"
4 Iron	1.5"
5 Iron	2"
6 Iron	2.5"
7 Iron	3"
8 Iron	3.5"
9 Iron	4"
Wedges	4.5"

*- Tip trim for desired club. Butt Trim to length.

Stiff Flex - Tip Trim To Length, No Butt Trim Required

Shaft Spine Alignment(Individual)

Price: $6.00

DTG's 24hr 50ml Epoxy Syringe

Price: $8.50